Phone
Email
FacebookInstagramXLinkedIn
ASHNET Logo

Vodafone / One NZ Router Settings

Set your Vodafone / One NZ router to DHCP and tag VLAN 10 – the steps and menu names for Vodafone / One NZ firmware.

Before you start

Connect the router's WAN / internet port to the port on your fibre box (ONT) that we activated – it is in your activation email, and it is usually the one with the light on. Then open the router's settings page.

Vodafone / One NZ settings page
Settings page192.168.1.1 (some models 192.168.0.1)
Sign in withadmin / admin, or the details on the label

1. Set the internet connection to DHCP

  1. Switch the interface to Advanced mode, then go to Settings > WAN.
  2. On the fibre WAN entry set Connection type to IPoE and IP address mode to Dynamic (DHCP).

2. Tag the internet VLAN (VLAN 10)

  1. On the same WAN entry set Internet VLAN ID to 10 and Priority to 0.
  2. Save, then Apply – the router restarts.

3. Check it works

Give the router a minute, then look at its status page: the WAN or internet section should show an IP address from us. Open a website to confirm. If the WAN stays blank, the VLAN or the DHCP setting has not taken – check both, then restart the router.

Many Vodafone/One NZ hubs are locked to their network. If the WAN settings are greyed out, the unit cannot be used on ASH NET.

Vodafone / One NZ models

A settings page for each Vodafone / One NZ model we have seen on New Zealand fibre. If yours is not here the steps above still apply – the menus are the same across the brand.

Vodafone Huawei B525 / B525s-65aSettings guideManufacturer’s page
Vodafone Ultra HubSettings guideManufacturer’s page
Vodafone Ultra Hub PlusSettings guideManufacturer’s page

The ASH NET settings in full

ASH NET fibre settings
Connection typeDynamic IP / DHCP (also called IPoE or "obtain an IP automatically")
Username & passwordNone – ASH NET does not use PPPoE
VLAN ID10, tagged (802.1Q) on the internet connection
VLAN priority (802.1p)0
MTU1500
IPv6Optional – leave on automatic
Router portThe WAN / internet port, into the lit port on the fibre box (ONT)

Routers we recommend

These arrive set up for ASH NET – plug them into the fibre box and they work. On a 12-month plan you can rent one for $7.50 a month instead of buying.

TP-Link HX510 AX3000Wi-Fi 6, pre-configured for ASH NET$149.50 incl. GSTTP-Link VX230v AX1800Wi-Fi 6 with a phone port for your home line$149.50 incl. GSTMercusys Halo H47BEWi-Fi 7 mesh for Hyperfibre$299 incl. GST

Still stuck? Email [email protected] with the router make and model and a photo of the screen, or call 09 269 4000. We can also supply a pre-configured router – see the shop.

All brands