Before you start
Connect the router's WAN / internet port to the port on your fibre box (ONT) that we activated – it is in your activation email, and it is usually the one with the light on. Then open the router's settings page.
| Settings page | 192.168.8.1 |
| Sign in with | admin / admin |
1. Set the internet connection to DHCP
- Go to Network > WAN Setup and edit the connection (cog icon).
- Set Service type to IPoE and Protocol to IPv4, with the IP obtained automatically.
2. Tag the internet VLAN (VLAN 10)
- On the same screen set VLAN operation mode to Tag.
- Set Internet VLAN ID 10 and Priority 0, then save.
3. Check it works
Give the router a minute, then look at its status page: the WAN or internet section should show an IP address from us. Open a website to confirm. If the WAN stays blank, the VLAN or the DHCP setting has not taken – check both, then restart the router.
Sky broadband routers are usually locked to Sky. If the WAN menu is missing or the settings will not save, the unit cannot be used on ASH NET.
Sky models
A settings page for each Sky model we have seen on New Zealand fibre. If yours is not here the steps above still apply – the menus are the same across the brand.
No model matches – the steps above still apply, or email us the model.
The ASH NET settings in full
| Connection type | Dynamic IP / DHCP (also called IPoE or "obtain an IP automatically") |
| Username & password | None – ASH NET does not use PPPoE |
| VLAN ID | 10, tagged (802.1Q) on the internet connection |
| VLAN priority (802.1p) | 0 |
| MTU | 1500 |
| IPv6 | Optional – leave on automatic |
| Router port | The WAN / internet port, into the lit port on the fibre box (ONT) |
Routers we recommend
These arrive set up for ASH NET – plug them into the fibre box and they work. On a 12-month plan you can rent one for $7.50 a month instead of buying.
Still stuck? Email [email protected] with the router make and model and a photo of the screen, or call 09 269 4000. We can also supply a pre-configured router – see the shop.